Once it's loaded (this may take a few seconds), you should start to see response from the faders, knobs, and buttons. Now, you should be able to open Logic and it will automatically load this new preference file. If given the option, make sure to select Replace and not Rename. This should replace an existing file of the same name in this folder. Find the .cs file in your MIDIMix_LogicProX folder and drag it into this Preferences folder.In the window that appears, navigate into the Library and find the Preferences folder.Hold down the Option key and click on Library when it appears in the list.Open a finder window and click on Go at the top of your screen.This will overwrite any "learned" control assignments previously made in Logic Pro X. Important: In order to share a mapping profile for Logic Pro X, the control surface preference file must be replaced. Installing the Control Surface Preference File Your preset should now be loaded and you are ready to install the control surface preference file! For more information on useing the MIDIMix Editor, please be sure to go through our Using the Editor guide. If asked to select your MIDI ports, choose the MIDImix option in the Output section and click Apply and OK. Follow our Akai Pro MIDIMix - Using the Editor guide for more information on receiving and saving presets from the MIDIMix.Ħ. If this is important, please make sure to back up your preset first. Important note: Sending a new preset to the hardware will replace all current parameter assignments on the MIDIMix. In the new window, select File > Send to Hardware. A new window will appear for the new preset. In the window that opens, locate the MIDIMix_LogicProX folder (this is likely in your downloads folder) and select the file MIDImix_LogicProX preset file inside.ĥ. From the top left of the editor window, select File > Open Preset.Ĥ. Close all other Audio/MIDI software, including Logic and launch the editor.ģ. Connect your MIDIMix to a USB port on your computer and power it on.Ģ.
0 Comments
Leave a Reply. |